Proper Use; For Safe Operation; Safety Information - LED2WORK INROLED 50 Power Ecolab AC User Instructions

INROLED_50

1 | Proper use

The luminaire is used for illumination. The luminaire is intended for mounting in a lumi-
naire holder or mounting bracket.
For connection values see "Technical data". The supply cable is connected to the lumi-
naire via an M12 plug connection.
The safety information and all other information in this manual must
be followed. Read the entire operating manual carefully before
mounting and turning on.
Keep the operating manual with the device. It must be stored and
handed over to third parties when the product is passed on.
Field of application: for systems and other lighting in the Food and
beverage industry
HACCP certificated and Ecolab certificated

2 | For safe operation

The operating parameters of the LED luminaire specified on the type plate must cor-
respond to the supply parameters of the machine or of the transformer.
Under no circumstances may the luminaire be covered with cloths,
foils or similar. Object distance from the luminaire should be at
least 10 cm.
Machines or systems can emit voltage spikes due to various
factors. These voltage spikes in the power supply via machines,
systems or units should be avoided.
During the operation of the luminaire in a 220 -240V power supply net, it could be
the cause, that machines (induction perpetrators) inside the same power supply net
cause interference spikes at start. This deviations may only 10% max.
Operate the luminaire only in a mounted status. Do only connect the luminaire in a
load free condition. Hot plugging can destroy the LEDs.

3 | Safety information

Installation of electrical equipment may only be carried out by quali-
fied electricians.
Follow the five safety rules according to DIN VDE 1005.
Failure to do so may result in damage to the LED luminaire, as well
as fire or other hazards.
Danger of electric shock! Disconnect before working on the
device or load. Ensure to disconnect all circuit breakers that supply
dangerous voltages to the device or load, when doing so. Even
when the device is switched off, the load is not galvanically isolated
from the mains.
AC
| 9
www.led2work.com