Jaquet MultiTasker T601 Instruction Manual page 10

Instruction Manual T601
Input signal for adaptive
trigger min. 500 mVpp
(+/-10 %) 180 mV
RMS
Sensor supply
Integral pull up resistor
Screen
Revision: 004
•
Max. voltage: 80 V
•
DC-decoupled
•
The Trigger level automatically adapts itself to the input signal in the range
+250 mV to +2 V. The Adaptive Trigger improves the signal to noise immunity
e.g. where electromagnetic sensors are used.
Min. Trigger level: 500 mVpp +/-10% = 180 mV
1000.0
100.0
10.0
1.0
0.1
•
+14 V +/- 0.5 V, max. 35 mA / Short circuit proof
•
If the current limit has been activated, then the circuit needs to be disconnected
to reset the protection.
Typical voltage curve as a function of sensor current
14.8
14.6
14.4
14.2
14.0
13.8
13.6
0 5
1000  to +14 V (Only for 2 wire active e.g. NAMUR sensors)
Terminals are provided for each sensor cable screen (Sh1 and Sh2). These
terminals are internally connected to the ground of the sensor input.
(226 V )
RMS pp
RMS
O.K.
NOT O.K.
Frequency (Hz)
Sensor voltage = f (Sensor current)
10 15 20
Sensor current (mA)
+/-10% U min. = f(Frequency)
25 30 35 40
JAQUET AG
45
10/73