How To Use - PrintDry FD1908-120 Instruction Manual

BEFORE FISRT USE
Unpack and remove all parts and packaging materials from the carton.

DO NOT plug in the power cord before reading the instructions.

Wipe the base with a slightly damp cloth. NEVER IMMERSE THE BASE IN

WATER OR ANY OTHER LIQUID.

3. HOW TO USE

PrintDry filament dryer offers two functions – Dry and Feed+Dry:
 Dry Function
1 Prepare filament spools with the mounting rods and mounting adaptors, as
shown in the figure below.
2 Put filament spools into the dryer with the mounting rod being supported on
the slot of the plastic tray and the center support piece.
3 Place the dryer base unit on a flat, smooth heat-proof surface. Plug into
wall outlet, press ON/OFF switch to turn on and select the appropriate
temperature for the filament as indicated in this manual.
4 Press "+" and "-" buttons together to enter into the timer setup. Use "+" and
"-" button respectively to set the timer (1 - 48 hours) for auto-shut-off.
5 When drying is completed, remove filament spools and store them in the
filament container if possible with desiccants pouches inside.
6 Use power switch to turn off & wait 1 minute to unplug from outlet.
7 Follow the instructions in the 'Care and Maintenance' section.
Fig.5 Assemble Filament Spool
- 7 -