Important Safeguards - PrintDry FD1908-120 Instruction Manual

1. IMPORTANT SAFEGUARDS

When using an electrical device, basic safety precautions should always be followed,
including the following:
Read all instructions before using the PrintDry filament dryer (hereinafter referred

as the "dryer").
Always use a heat resistant surface.

DO NOT touch hot surfaces.

To protect against electrical hazards, DO NOT immerse cord, plug or the dryer in

water or any other liquid. DO NOT switch the dryer ON if surfaces are wet.
Do not allow children to use the dryer, close supervision is necessary when the

dryer is used near children.
Unplug from outlet when not in use and before cleaning. Allow to cool before

putting on or taking off parts.
DO NOT operate the dryer with a damaged cord or plug or after the dryer

malfunctions, or has been damaged in any manner. Return the dryer to the
manufacturer for examination, repair or adjustment. See Warranty section.
The use of accessories/attachments not recommended may cause hazards.

DO NOT use outdoors.

DO NOT let cord hang over edge of table or counter, or touch hot surfaces.

DO NOT place on or near a hot gas or electric burner, or in a heated oven.

DO NOT block the air vents.

DO NOT use for other purposes other than the intended use.

To disconnect, turn the power switch to 'OFF', then unplug from wall outlet.

DO NOT pour liquids into the dryer.

DO NOT leave the dryer unattended while in use at any time.

DO NOT operate near combustible or pressurized spray cans.

DO NOT use the dryer more than 48 continuous working hours. After a maximum

of 48 hours in use, turn OFF and unplug the dryer for at least 1 hour.
Leave a minimum 250mm (12") open space all around the exterior of dryer.

The use of unauthorized accessories may cause injuries.

Store in a dry & clean place. Do not drop, knock or shake the dryer. Rough

handling can break the internal circuit board & diminish product performance.
- 2 -