Table of Contents
Advertisement
Maintenance
Through careful and regular maintenance, inspections, and overhauls you can detect faults
at an early stage and resolve them. This means that you can avoid consequential damage.
Operating conditions and characteristics can vary widely. For this reason, only general
maintenance intervals can be specified here. Maintenance intervals should therefore be
scheduled to suit the local conditions (dirt, starting frequency, load, etc.).
Observe the following when carrying out any work on the machine:
● Comply with the general safety instructions (Page 11).
● Comply with the applicable national and sector-specific regulations.
● When using the machine within the European Union, comply with the specifications laid
down in EN 50110-1 regarding safe operation of electrical equipment.
Comply with the IEC / EN 60079-17 standard during all service and maintenance work on
the machine.
9.1
Customs union Eurasia (optional)
When making changes or repairs, maintain the corresponding design standards! These
machines are labeled on the rating plate with the following markings.
Note
Please contact the service center (Page 159), if you require support with service,
maintenance or repair.
1MB..1/2/3/4 - shaft heights 63 ... 355
Operating Instructions, 06/2020, A5E44455710A
Customs union Eurasia
Eurasian customs union
Explosion-protected
9
109
Advertisement
Table of Contents
