Safety Guidelines - ADJ HYDRO BEAM X2 User Instructions

Hydro Beam X2
FOR YOUR OWN PERSONAL SAFETY, PLEASE READ AND UNDERSTAND THIS
MANUAL COMPLETELY BEFORE YOU ATTEMPT TO INSTALL OR OPERATE THIS UNIT!
• THERE ARE NO USER SERVICEABLE PARTS INSIDE THIS UNIT. DO NOT ATTEMPT ANY
REPAIRS YOURSELF; DOING SO WILL VOID YOUR MANUFACTURES WARRANTY. DAMAGES
RESULTING FROM MODIFICATIONS TO THIS FIXTURE AND/OR THE DISREGARD OF SAFETY
INSTRUCTIONS AND GUIDELINES IN THIS MANUAL VOID THE MANUFACTURES WARRANTY
AND ARE NOT SUBJECT TO ANY WARRANTY CLAIMS AND/OR REPAIRS.
• DO NOT PLUG THE FIXTURE INTO A DIMMER PACK! NEVER OPEN THIS FIXTURE WHILE IN
USE! UNPLUG POWER BEFORE SERVICING FIXTURE! NEVER TOUCH THE FIXTURE DURING
OPERATION AS IT MAY BE HOT! KEEP FLAMMABLE MATERIALS AWAY FROM FIXTURE!
ENSURE ALL CONNECTIONS AND END CAPS ARE PROPERLY SEALED WITH A DIELECTRIC
GREASE (AVAILABLE AT MOST ELECTRICAL SUPPLIERS) TO PREVENT WATER CORROSION
AND/OR ELECTRICAL SHORT CIRCUIT.
• IF THE FIXTURE IS EXPOSED TO ENVIRONMENTAL TEMPERATURE CHANGES SUCH AS
RELOCATION FROM AN OUTDOOR COLD TO AN INDOOR WARM ENVIRONMENT, DO NOT
POWER THE FIXTURE ON IMMEDIATELY. INTERNAL CONDENSATION AS A RESULT OF
ENVIRONMENTAL TEMPERATURE CHANGE CAN CAUSE INTERNAL FIXTURE DAMAGE.
LEAVE THE FIXTURE POWERED OFF UNTIL IT HAS REACHED ROOM TEMPERATURE
BEFORE POWERING ON.
• NEVER LOOK DIRECTLY INTO THE LIGHT SOURCE! RETINA INJURY RISK - MAY INDUCE
BLINDNESS SENSITIVE PERSONS MAY SUFFER AN EPILEPTIC SHOCK!
• Replace shields, lenses or ultraviolet screens if they have become visibly damaged to such an extent
that their effectiveness is impaired, for example by cracks or deep scratches.
• Change the lamp if it has become damaged or thermally deformed.
• The luminaire is intended for professional use only.
• The light source contained in this luminaire shall only be replaced by the manufacturer, qualified
service agent, or a similar qualified technician.
• Reinforced insulation is located between LV supply and DMX dimming control circuit.
• No insulation located between SELV circuit and DMX dimming control circuit.
• Be sure that the local power outlet is compatible with the required voltage for your unit. • Do not attempt
to operate this unit if the power cord has been frayed or broken.
• Do not attempt to remove or break off the ground prong from the electrical cord. internal short.
• Disconnect from main power before making any type of connection.
• Do not remove the cover under any conditions. There are no user serviceable parts inside. • Never
operate this unit when it's cover is removed.
• Always be sure to mount this unit in an area that will allow proper ventilation. Allow about 6"
(15cm)between this device and a wall.
• Do not attempt to operate this unit, if it becomes damaged. • Always mount this unit in safe and stable
matter.
• Power-supply cords should be routed so that they are not likely to be walked on or pinched by items
placed upon or against them, paying particular attention to cords at plugs, convenience receptacles,
and the point where they exit from the appliance.
• Cleaning -The fixture should be cleaned only as recommended by the manufacturer.
• Heat -This fixture should be situated away from heat sources such as radiators, heat registers, stoves,
or other appliances (including amplifiers) that produce heat.
• The fixture should be serviced by qualified service personnel when the appliance does not appear to
operate normally or exhibits a marked change in performance.
ADJ Products, LLC - www.adj.com - Hydro Beam X2 User Manual

Safety Guidelines

Page
7