Lamp Installation - ADJ HYDRO BEAM X2 User Instructions

Hydro Beam X2

LAMP INSTALLATION

WARNING! LAMP REPLACEMENT SHOULD ONLY BE DONE BY A TRAINED
TECHNICIAN.
1. Turn OFF power and allow approximately 60 minutes for the fixture to cool down.
2. Unscrew the (4x) Allen Head Screws to remove the rear cover. When removing the rear cover,
please be advised that the cover is connected to the unit via a safety cable and connected wire
cable.
3. Gently remove the (2x) spade terminals
connected to the lamp.
ADJ Products, LLC - www.adj.com - Hydro Beam X2 User Manual
4. Loosen the Phillips head screw to unlock
the lamp holding slider.
Lamp Installation
Page
14