EcoFlow R600 User Manual page 3

Table of Contents

Advertisement

10. Do Not allow pins, wires or other metal pieces to insert to the device case, outlets or controls. Metal pieces
may short circuit the product.
11. Avoid collision. DO NOT place heavy objects on the machine.
12. If there is dirt on any plug or outlet surface, use a dry cloth to clean it. Otherwise, it will cause abrasion and
result in energy loss or inability to charge.
Product Charging:
1. Always use EcoFlow approved charging cables. EcoFlow does not response to any damage caused by using
non-EcoFlow charging cable.
2. When charging, please place the product on the ground with no flammable or combustible materials around.
To prevent accidents, never leave the machine unattended during charging.
3. DO NOT charge a product immediately after a long heavy load, because theproduct's temperature may be
too high. DO NOT charge a product until it cools down to room temperature. The product may be unable to
charge out of the temperature range 32ºF to 104ºF (0 to 40℃). The ideal charging temperature range is 71ºF to
82ºF(22℃ to 28℃).
Product Storage and Transportation:
1. Keep the product out of the reach of children. If any children accidentally swallow parts, please go to a doctor
immediately.
2. If a low-battery warning appears, charge the battery before store it. Otherwise, long-term storage may cause
damage to the battery in the product. Batteries in the product will enter hibernation mode if it is depleted and
stored for a long time. Recharge the product can bring the battery out of hibernation.
3. DO NOT place the product near a heat source, such as a car in direct sunlight, a fire source, or a heating stove.
4. Store the product in dry environments. DO NOT place the product where it may contact with water.
5. Make sure no small metal objects can fall on or around the product while in storage.
6. Never transport a product with a battery power level higher than 30%.
Product Battery Disposal:
1. Dispose the product in specific recycling boxes only after a complete discharge. Batteries are hazardous
chemicals. Please strictly follow your local regulations regarding the battery disposal and recycle.
2. Dispose of the product immediately if it cannot be powered on after over-discharging.
Product Maintenance:
1. Never store the product in environments below -4ºF (-20℃) or above 140ºF (60℃).
2. If the product is not used for a long time, the battery life may be reduced.
3. Fully charge and discharge the battery at least once every 3 months to keep the battery healthy.
Travel Notice:
It is forbidden to carry lithium batteries and equipment with a capacity greater than 160Wh on airplane due to
the regulation; Do Not bring this product on flights.
R600 Use Care and Safety Guide
CONGRATULATIONS!
You now own the best quality Portable Battery Generator in the world. This brief pamphlet is meant to help
you. Please take some time to read it before using the product. Read it through to fully understand how to
use the Lithium Generator!
NOTICE
To turn R600 on or off, you need to PRESS and HOLD the ON/OFF Power Button. To turn on the AC power
outlet, you need to PRESS and HOLD the AC Button after turning on R600. We set the AC button for users to
turn off AC power when they don't need it to save power usage. Please follow this introduction step-by-step
to be familiar with each of R600's ports, buttons, display screens and more. Please fully charge (100%) your
R600 before use it.

Advertisement

Table of Contents
loading

Table of Contents