NEUTRIK opticalCON QUAD Handling Instructions Manual page 3

F
Dry Cleaner 1.25 mm
(FOCD-DC125)
Picture A:
BDA 522
D
E
Picture B:
opticalCON QUAD ®
1.4 Insert the video probe tool into our NEUTRIK FOCD-
STQ service tool (D).
To inspect the LC ferrule surface focus the video
1.5
probe by rotating the focus wheel (E).
Clean the LC surface with the Dry Cleaner 1.25 mm
1.6
over the NEUTRIK QUAD service tool.
Push back and forth the dry cleaner to start the
1.7
cleaning procedure (F). An endless lint free tape
removes dust particle on the ferrule surface of the LC
connector.
Check the condition of the LC ferrule surface again
1.8
and if necessary repeat step 7.
D u r i n g i n s p e c t i o n p r o c e d u r e , m a k e s u r e
that each ferrule is completely free of dust.
As a reference the ferrule has to look as
illustrated on Picture B.
I
HANDLING INSTRUCTION
3