Programming
17.4.5 Setting the Fullness degrees (Fullness) parameter
Fullness degrees range:
To set the Fullness degrees parameter:
1. Select the Fullness parameter.
2. Press the OK button to confirm the selection.
3. Enter the desired value (
4. Press the OK button to confirm the value.
17.4.6 Setting the Start bartack (StartTack) parameter
Setting whether the start bartack is automatically activated in a new
program.
Menu item
On
Off
17.4.7 Setting the End bartack (EndTack) parameter
Setting whether the end bartack is automatically activated in a new
program.
Menu item
On
Off
17.4.8 Setting the Thread Trim (ThreadTrim) parameter
Setting whether the thread trim is automatically activated in a new program
or not.
Menu item
On
Off
Service Instructions 878-M PREMIUM - 03.0 - 10/2019
0 – 16.
.
0 – 16)
Setting option
The start bartack is activated automatically. The values for the start
bartack are taken from Manual mode.
The start bartack is not activated.
Setting option
The end bartack is activated automatically. The values for the end
bartack are taken from Manual mode.
The end bartack is not activated.
Setting option
The thread trim is activated automatically at the end of a seam section
and at the end of the sewing program.
The thread trim is not activated.
69