Table of Contents
Advertisement
16
S a b r i n a X I n s t a l l a t i o n a n d C a r e
Note: In your listening room or home theater, clear out t wo spaces, one for
your lef t and one for your right channel. Place the ODD numbered SabrinaX
in the LEFT channel sec tion and the EVEN in the RIGHT channel sec tion.
Section 2�1—Uncrating the SabrinaX
Note: To avoid damaging the SabrinaX's painted surface. Please remove any
jewelry such as rings, watches, necklaces, and bracelets during this process.
Initial Check
The SabrinaXs are shipped in boxes. Upon receiving these boxes, please
check their condition. If any of the boxes are damaged, please repor t it to the
shipping company immediately for insurance verification.
The following items are recommended for this procedure:
•
Box Cutter
•
Tin Snips (for cutting bands)
•
Masking tape (for use in speaker setup)
Uncrating the SabrinaX
A minimum of two strong adults is required to set up the SabrinaXs.
1.
Using tin snips, carefully cut the metal bands around the box.
2.
With the box facing up, carefully cut the tape securing the lid.
Slide off the outer cardboard shell.
A u t h e n t i c
G u i d e
E x c e l l e n c e ™
S e c t i o n 2 . 2 – T o o l b o x C o n t e n t C h e c k l i s t
3.
One box will contain the tool kit. Carefully remove the toolkit
and the manual. Set these aside.
4.
Carefully lift the box upright so that the SabrinaX is now
ver tical. With the SabrinaX's bottom toward the floor and one
person holding the box, the second person should reach in and
gently slide the SabrinaX out of the box.
5.
Place the SabrinaX with an odd serial number on the left side
of the room and the SabrinaX with an even serial number on
the right side of the room.
Note: The SabrinaXs are very heavy and care should be taken to prevent injury.
Section 2�2 – Toolbox Content Checklist
Now that you have unpacked your SabrinaX, you can inventor y all the
additional items in the boxes.
•
Polishing Cloth
•
8x Spike with Nut
•
8x Spike Diodes
•
8x Aluminum Spike Pads
•
Universal Handle
•
1/2" Nut Driver (binding posts)
•
1/4" Allen Wrench
•
3/4" Combo Wrench (spike nuts)
•
5/32" Ball-End Allen (driver screws)
•
1/8" Ball-end Allen head for bottom resistor panel
W i l s o n
A u d i o
S p e c i a l t i e s
1 7
Advertisement
Table of Contents
