S E C T I O N 3 . 1 - S E T T I N G U P S A B R I N A; P R E P A R A T I O; S E C T I O N 3 . 2 - S A B R I N A X S P I K E; S P I K E / D I O D E A S S E M B L - WILSON AUDIO SabrinaX Installation And Care Manual

20
S a b r i n a X I n s t a l l a t i o n a n d C a r e
Note: Before setting up the SabrinaX, study carefully Sec tion 1, " WASP Set-
up." It provides valuable information on determining the ideal room loca-
tion for your speakers.
Section 3�1—Setting up SabrinaX
Preparation
You will need the following items:
• Supplied hardware kit
• Tape measure
• Known listening position
Your dealer is trained in the ar t and science of the Wilson Audio Setup
Procedure ( WASP) outlined in Section 1. Before the spike assemblies are at-
tached to the bottom of your SabrinaXs, the set up and fine tuning of your loud-
speaker should be completed. Before spiking your SabrinaXs, use masking tape
to carefully mark their location.
Section 3�2—SabrinaX Spikes
Spike/Diode Assembly
1. The spike assembly consists of four elements: the diode, the
spike, the all-thread post, and the locking nut. The spike and
A u t h e n t i c
G u i d e
Watch the spike-assembly video
E x c e l l e n c e ™
S e c t i o n 3 . 2 — S a b r i n a X S p i k e s
nut are shipped assembled. Retrive these items from the tool-
kit.
2. On the spike, move the nut to about three threads from the
point. This will allow for greater movement when leveling the
loudspeaker system.
3. Screw the spikes into the diode until the nut is against the
diode. Be careful that the nut does not turn while inser ting and
threading spikes into the diode.
Note: Do not tighten the nut on the assembled spikes. You will need to
loosen them when you level the SabrinaX.
4. Screw the all-thread post into the diode until it just meets the
spike. Make sure the Allen head por tion of the all-thread faces
toward the spike. Do not over tighten; doing so will prevent the
spike from being adjusted for leveling.
5. Assemble the rest of the spikes/diode.
Spike Installation Procedure
6. Carefully lay the SabrinaX on its side.
7. Inser t the spike/diode assemblies into the four holes located
on the bottom of each loudspeaker. Tighten until the top sur-
W i l s o n A u d i o S p e c i a l t i e s
2 1