Page 1
Instructivo de Bomba Para agua LIMPIA sumergible de hierro fundido Este instructivo es para: Modelos Códigos BOS-1/2LH 100169 BOS-3/4LH 100170 BOS-1LH 100171 BOS-1/2LH BOS-3/4LH BOS-1LH Lea este instructivo por completo ATENCIÓN antes de usar la herramienta.
Guarde este instructivo para futuras referencias. Puesta en marcha Los gráficos de este instructivo son para referencia, pueden variar del aspecto real de la Mantenimiento herramienta. Solución de problemas Notas Centros de Servicio Autorizados Póliza de Garantía BOS-1LH BOS-3/4LH BOS-1/2LH ESPAÑOL...
Especificaciones técnicas BOS-1/2LH BOS-3/4LH BOS-1LH Código 100169 100170 100171 Descripción Bomba sumergible de hierro fundido Tensión y Frecuencia 127 V 60 Hz Corriente 7,7 A 9,6 A Potencia 370 W (1/2 Hp) 560 W (3/4 Hp) 750 W (1 Hp)
Advertencias generales de seguridad para herramientas eléctricas ¡ADVERTENCIA! Lea detenidamente todas las advertencias de seguridad y todas las instrucciones que se enlistan a continuación. La omisión de alguna de ellas puede dar como resultado un choque eléctrico, incendio y/o daño serio. Conserve las advertencias y las instrucciones para futuras referencias. Área de trabajo No sobrepase su campo de acción.
Page 5
La máquina no debe de ser utilizada por niños ni por personas con capacidades físicas, sensoriales o mentales reducidas; tampoco por personas sin experiencia o conocimientos en su uso, a menos que estén supervisadas por una persona responsable de su seguridad o reciban instrucciones previas sobre el uso de la máquina. Los niños deben de estar bajo supervisión para asegurarse de que no jueguen con la máquina.
Partes Asa de transporte Seguro del flotador ajustable Cable de alimentación Interruptor de flotador Salida de agua (Adaptador para manguera) Base de succión ESPAÑOL...
Instalación ATENCIÓN • Antes de instalar, confirme que la bomba, el cable y clavija no presenten golpes o daños debidos a su transporte o almacenamiento. • Conecte la manguera a la salida de agua (adaptador para manguera A). Use una abrazadera para sujetar las mangueras suaves y una brida soldada para mangueras de acero.
(D) para que el flotador no favor acuda a un Centro de Servicio Autorizado Truper. pueda bajar y apagar la bomba. • Después de haber bombeado agua clorada de una alberca, •...
Solución de problemas Problema Causa Solución La bomba no • No hay corriente eléctrica. • Revise el cable, la clavija y el fusible. enciende o se detiene • El flotador no cambia de • Coloque la bomba de manera adecuada en la pileta, de repente durante la posición.
Centros de Servicio Autorizados En caso de tener algún problema para contactar un Centro de Servicio consulte nuestra página www.truper.com donde obtendrá un listado actualizado, o llame al teléfono: (800) 690-6990 ó (800) 018-7873 donde le informarán cuál es el Centro de Servicio Autorizado más cercano.
. Los gastos de transportación que resulten para su cumplimiento serán cubiertos por . Para dudas o comentarios, llame al 800-690-6990. Importado por: Truper, S.A. de C.V. , Parque Industrial #1, Jilotepec, Edo. de Méx., Méx. C.P. 54240, Hecho en China Sello del establecimiento comercial: Fecha de entrega: www.truper.com...
Page 13
Manual Iron Cast For CLEAN water Submersible Pump Applies for: Models Codes BOS-1/2LH 100169 BOS-3/4LH 100170 BOS-1LH 100171 BOS-1/2LH BOS-3/4LH BOS-1LH Read this manual thoroughly CAUTION before using the tool.
Page 14
Installation Keep this manual for future references. Start up The illustrations in this manual are for reference Maintenance only. They might be different from the real tool. Troubleshooting Notes Authorized Service Centers Warranty BOS-1LH BOS-3/4LH BOS-1/2LH ENGLISH...
Technical data BOS-1/2LH BOS-3/4LH BOS-1LH Code 100169 100170 100171 Description Iron Cast Submersible Pump Voltage and Frequency 127 V 60 Hz Current 7,7 A 9,6 A Power 1/2 Hp 3/4 Hp 1 Hp Speed 3 500 RPM Flow Rate 1902 gal/h...
General Power Tool Safety Warnings WARNING! Read carefully all safety warnings and instruction listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references.
Safety Warnings for Submersible Pumps CAUTION • Any change or modification to the Correct Use of the Pump pump and the use of non-approved spare parts could • This line of submergible pumps is designed to pump damage the equipment and cause accidents. WARNING fresh and clear water from springs, wells and other water •...
Installation CAUTION • Before installing double check the pump, cable and plug are not showing any damage due to transportation and storage. • Connect the hose to the water outlet (hose adapter A). Use a clamp to fasten the soft hoses and a soldered flange for steel hoses.
NOTE: If the cable through the transport handle (D) so that the float pump shuts down again, please contact a Truper Authorized cannot plunge down and shut off the pump. Service Center.
Troubleshooting Problem Cause Solution The pump cannot be • No power. • Check the cable, plug and fuse. turned on or it • The float is not changing its • Set the pump correctly into the pool, well, etc. suddenly stops while position.
Authorized Service Centers In the event of any problem contacting a Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers (800) 690-6990 or (800) 018-7873 to get information about the nearest Authorized Service Center.
. For questions or comments, call 800-690-6990. Imported by: Truper, S.A. de C.V. , Parque Industrial #1, Jilotepec, Edo. de Méx., Méx. C.P. 54240, Made in China Stamp of the business: Delivery date: www.truper.com...
Need help?
Do you have a question about the BOS-1/2LH and is the answer not in the manual?
Questions and answers