Sealey BS3.V3 Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instruction
manual
1. safety
DO nOt use the cycle carrier if any parts are missing or damaged as this may cause failure or possible personal injury.
8
Warning! due to the variety in design of vehicles & cycles, it is the user's full responsibility to ensure no damage occurs whilst
ˆ
using this cycle carrier. correct attachment of carrier to a vehicle is therefore critical and is beyond control of the manufacturer,
distributor, or supplier.
Warning! the user must secure the carrier and any cycles to be carried properly, checking the security frequently when in use.
ˆ
use strong, good quality tie restraints for securing cycles to the carrier. DO nOt use string, or elasticated straps.
9
if your vehicle lights and/or number plate are obscured by your bikes, you are required by laW to replicate them with an
9
auxiliary lighting kit.
Warning! Make an assessment of the suitability of the carrier to fit the vehicle. Refer to the manufacturer's handbook to find the
ˆ
suitability of attachment points. consider the position and strength of spoilers, large glass panels and large body panels. Be aware
of when the rear wiper will operate automatically.
Avoid damage caused by hot exhaust fumes do not position cycles directly next to the vehicle's exhaust, especially the bicycle
9
tyres. If necessary fit an exhaust deflector.
ensure that bicycles do not come into contact with the vehicle bodywork and provide protection as required.
9
Warning! remove any loose objects from the bikes i.e pumps, bottles etc.
ˆ
Warning! Avoid any protrusions beyond the side of the car as these may present a risk of injury to passers-by.
ˆ
DO nOt use the cycle carrier for any purpose other than for which it is designed.
8
DO nOt strap any other items to the carrier, only bicycles.
8
Warning! drive carefully - Be aware of cross winds, sudden braking or hard cornering, reduce speed accordingly when using
ˆ
carrier.
Warning! this carrier is designed for temporary use only, remove when not in use or before going through a car wash.
ˆ
Every time before use check the carrier for security of fittings or any sign of wear and tear. Replace any worn or damaged parts.
9
Warning! remember the driver of the vehicle is responsible for the security and safety of the load carried.
ˆ
2. intrODuctiOn
rigid yet lightweight carrier designed to fit most saloons, hatchbacks, vans, estates and coupés. Carries up to 3 standard bicycles. Includes
five nylon fixing straps and foam rubber tubes for protection of vehicle at contact points. Folds for easy storage. Available separately; set of
adaptors for use when fixing straps of bicycle carrier to glass edged hatches - order Model no. BS3/1.
© Jack sealey limited
instructions for
rear bicycle carrier 5 strap fixing
maximum 3 bicycles
bs3.V3
model no:
Original Language Version BS3.V3| Issue 1 06/10/15