Sealey VS7105 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools.
‰
DO NOT use tools if damaged.
8
Maintain tools in a good, clean condition for best and safest performance.
9
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey stockist.
9
Wear suitable clothing to avoid snagging. DO NOT wear jewellery and tie back long hair.
9
Keep children and unauthorised persons away from the work area.
9
When not in use, store in a secure, childproof location.
9
Keep working area clean and tidy, dry and free from unrelated materials
9
Ensure the working area has adequate lighting
9
2. INTRODUCTION
Fastens and seals into the engine filler with three manufacturer specific adaptors. Covering a large proportion of modern vehicles for Audi,
Seat, Skoda and Volkswagen. Hands-free operation with no mess or spills. See instructions on Sealey website for complete list of vehicle
applications.
3. SPECIFICATION
Adaptors: 1 x 39mm Knob Type, 1 x Clip Type - 38mm, 1 x Ø45mm - Twist fitting
Knob Type
NOTE: Clip Type is a common type and details are therefore not included in the table below.
4. OPERATION
4.1. ASSEMBLY
4.1.1. Apply adhesive (not supplied) around the fine threads on the transparent chamber (fig.1).
4.1.2. Connect transparent chamber to the upper funnel part (fig.1) to form complete funnel.
4.2. IN USE
NOTE: Ensure engine is cool before using funnel.
4.2.1. Remove original oil cap on engine.
4.2.2. Connect oil funnel or funnel with relevant adapter to oil filler neck.
4.2.3. Make sure the funnel is securely connected to the engine before filling.
4.2.4. Disconnect oil funnel from oil filler neck after oil is refilled.
4.2.5. Clean residual oil inside the funnel and store the funnel in dry and well-ventilated place.
© Jack Sealey Limited
5PC ENGINE OIL FUNNEL SET - AUDI, SEAT,
SKODA AND VOLKSWAGEN
MODEL NO:
Wear protective
Wear safety
gloves
footwear
Clip Type
Original Language Version
VS7105
Wear protective
clothing
Twist Type
Funnel
Chamber
Adaptor
fig.1
Location
VS7105 Issue 1 24/05/22