Table of Contents
Advertisement
Available languages
Available languages
Problem
The water in the cavity em-
bossment does not boil.
The water comes out of the
cavity embossment.
The display shows "12.00".
SERVICE DATA
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
INSTALLATION
WARNING! Refer to Safety chapters.
Possible cause
The temperature is too low.
There is too much water in the
cavity embossment.
There was a power cut.
We recommend that you write the data here:
Set the temperature at least to
110 °C.
Refer to "Hints and tips" chap-
ter.
Deactivate the oven and make
sure that the appliance is cold.
Wipe the water with a cloth or
sponge. Add the correct
amount of water to the cavity
embossment. Refer to the spe-
cific procedure.
Reset the clock.
the oven cavity. Do not remove the rating plate from
the oven cavity.
.........................................
.........................................
.........................................
Remedy
25
Advertisement
Table of Contents
