Advertisement
NOTE: Leave all bolt connections untightened until
weight stack assembly is in position.
M
O
9
1. Bolt Rear Base (9) to Lower Frame (2) using bolts shown and four washers.
2. Loosely bolt two Lower Plates (4) to Lower Frame (2) using bolting shown.
3. Bolt Leg Extension (6) to Lower Frame (2) using two Leg Extension Brackets L&R (5) and the
bolting shown. Do not overtighten bolt (D).
4. Bolt Seat Pad (25) to Seat Support (10) using bolting shown.
5. Tighten the bolts holding the Seat Pad and position the Seat Support in the Lower Frame as shown.
6. With the Main Upright (1) on the floor, position the Top Assembly (3) and bolt loosely.
G
G
D
D
8
2
4
G
G G
O
O
1
C
D
4
D
G
G
25
10
L
5L
O
O O O
6
5R
3
O
Page:-4 of 9
Advertisement
