Advertisement
15
Jam Nut
23
9
28R
4 PLACES
N
20. Bolt Weight Stack Shroud (27)
& Wt Stack Front Shrouds R&L (28)
to Rear Base using bolting shown. Wt Stack Front Shrouds
must be installed over Weight Stack Shroud (27).
21. Install Edge Trim (AS).
22. Slide on all Foam Rollers (29) and insert Foam Roller Caps (AI)
NOTE: Make certain that all cables are properly positioned on/around pulleys
before use and that all nuts have been tightened.
Cables are a consumable and must be treated as such. As a minimum, an annual inspection must
be performed on all cable ends and full lengths. A cable must be replaced immediately if broken
exposed wires and/or a break in cable coating are found.
AU
17
31
Selector
Pin
AS
28L
27
4 PLACES
4 PLACES
19. Complete the installation of the Top Cable (AU)
by threading the end of the cable into the
Selector Rod (17) until slackness in the cables
is removed.Tighten the jam nut against the
Selector Rod. Periodic cable tightening may
be required.
The hollow bolt provides approximately 1-1/4"
adjustment.
I I
I
I
AI
29
14
Page:-8 of 9
Advertisement
