Cleaning The Hinged Grill; What Happens If Something Goes Wrong - Zanussi ZSA 15 Operating And Installation Manual

CLEANING THE HINGED GRILL

This model has been fitted with a hinged top grill
element to enable you to clean the roof of the oven
easily.
Before proceeding ensure the oven is isolated from
the electricity supply. Then undo the screw which
holds the grill in place. (see Fig. 10)
FO 1168

WHAT HAPPENS IF SOMETHING GOES WRONG

If the oven does not come on:
* Check the oven is in manual operation
* Check that it is plugged in properly
* Check that the socket switch and/or the switch
from the mains supply to the oven are ON
* Replace the fuse in the plug, if required, with
another of the same rating and check that this plug
has been wired up correctly
* Check that the socket, when present, is receiving
power - by plugging in an appliance you know to
be working
* Check that the fuse in the fuse box is intact
In after all these checks, the oven still does not work,
contact your local Zanussi Service Centre quoting
your model and serial number.
18
Then gently pull the grill downward to allow access to
the oven roof. (see Fig. 11)
FO 1169
Clean the oven roof with a suitable clener and wipe
Fig. 10 dry before replacing the hinged grill element.
Gently push up the grill element into place and firmly
screw into place the holding nut.
NOTE: Ensure the grill holding nut is firmly in
place to avoid the grill falling down during
operation.
Please note that it will be necessary to provide proof
of purchase for any inguarantee service calls.
In-guarantee customers should ensure that the
above checks have been made as the engineer
will make a charge if the fault is not a mechanical
or electrical breakdown.
CUSTOMER CARE DEPARTMENT
For general enquiries concerning your Zanussi
appliance, contact our Customer Relations
Department by letter or telephone as follows:
Customer Care Department
Zanussi House
Hambridge Rd.
Newbury
Berks R14 5EP
Tel: 01635 - 521313
Fig. 11