Leader Evaporator Springtech MicRO Manual page 16

7. Measure a length of 1" braided hose to reach between the wash tank and the input fitting on the feed pump of
the system.
8. Place a 1" stainless steel band clamp onto each end of the braided hose.
9. Insert a Banjo "C" fitting into each end of the braided hose and tighten the clamp.
10. Connect the quick couplers by opening the latch on the "C" style coupler (position the metal latch arms out
perpendicular to the body of the coupler) then sliding the "C" coupler onto the "F" coupler. Pull the metal
latch arms back up to the sides of the "C" coupler.
To use the wash tank, connect one end of the braided hose to the bottom quick coupler of the wash tank and the
other to the quick coupler on the feed pump of the system.
Leader Evaporator Springtech MicRO Reverse Osmosis System Manual
1. Drill a hole in the bottom center of the bucket of sufficient size to
install the bulkhead fitting. Do not make the hole too large or the
bulkhead fitting will leak.
2. Install and tighten the bulkhead fitting into the prepared hole. The
Portion of the bulkhead fitting with the exterior threads should be on
the outside of the bucket.
3. Wrap both ends of the 1" PVC nipple with Teflon tape.
4. Screw one end of the 1" PVC nipple into the bottom of the bulkhead
fitting then tighten.
5. Thread the 1" PVC ball valve onto the other end of the 1" PVC close
nipple and tighten.
6. Teflon tape the threads of the Banjo "F" fitting and thread into the
other side of the 1" PVC ball valve.
YEAR: 2017 Page: 16