Pioneer PDP-425CMX Service Manual page 71

5
2-2. Factory shipment setting (Initial setting)
(1) Press the [CLEAR] or [ID SELECT] key to select the [FUNCTION] menu.
(2) Move the POSITION/CONTROL keys of [
POSITION/CONTROL keysof [
(The asterisks * shown below denote the numerals or the characters.)
A/J : PDP-425CMX/LUC5
G : PDP-42MXE10/LDFK5
CKD : PDP-42MXE10/YVXK5
(3) Press the keys in the order of [MUTE]→POSITION/CONTROL [
] →[MUTE] to make "Factory shipment setting". When "Factory shipment setting" is
∞
[
executed, the red characters of [SET] is shown for about 5 seconds on the right side of the
[DESTINATION ALPHABETS]. The setting is finished when these red characters of [SET] go out. In
regard to the factory shipment setting values, refer to the descriptions given below.
Press the keys of the remote control in the order of [PIP SHIFT] → [SET] → [CLEAR] → [PIP SHIFT]
(4)
in order to withdraw from the Factory shipment setting.
5
6
5
] and [
2 3
] and [ ] to select [DESTINATION ALPHABETS] shown below.
FUNCTION
SCART OFF
SHIP A
LIMIT-VD OFF
LIMIT-PC ON
12
GAMMA MD
2
VOL OFFSET
PSC-T OFF
EXT-PC OFF
[MENU/ENTER] NEXT [EXIT] PREV 10/10
FUNCTION
SCART OFF
SHIP A SET
LIMIT-VD OFF
LIMIT-PC ON
GAMMA MD 10
VOL OFFSET 2
PSC-T OFF
EXT-PC OFF
[MENU/ENTER] NEXT [EXIT] PREV 10/10
PDP-425CMX
6
7
∞
] to the item of [SHIP]. Then, move the
SAFEL MODE ---
PLE TEST OFF --
ROTATEPTN 1
5
] → POSITION/CONTROL
SAFEL MODE ---
PLE TEST OFF ---
ROTATE PTN 1
7
8
A
B
C
D
E
F
71
8