Section Control Room - RME Audio HDSPe AIO Pro User Manual

20.4 Section Control Room

In the section Control Room the menu Assign is used to define the Main Out which is used for
listening in the studio. For this output the functions Dim, Recall, Mono, Talkback and External
Input are automatically applied.
Additionally the channel will be shifted from the Hardware Out-
puts into the Control Room section, and renamed Main. The
same happens when assigning Main Out B or the Phones. The
original name can be displayed by the function Names in the
View Options - Show at any time.
Phones 1 to 4 will have Dim (set in Settings) and a special
routing applied when Talkback is activated. Also putting them
beside the Main Out increases the overview within the output
section greatly.
Dim. The volume will be reduced by the amount set in Settings
(F3), tab Mixer.
Recall. Sets the gain value defined in Settings - Mixer.
Speaker B. Switches audio from Main Out to Main Out B. The faders of the channels Main and
Speaker B can be ganged via Link. Via Options / Key Commands switching to Speaker B can
also be controlled by the F-keys F4 to F8.
Mono. Mixes left and right channel. Useful to check for mono compatibility and phase problems.
Talkback. A click on this button will dim all signals on the Phones outputs by an amount set up
in the dialog Settings - Mixer. At the same time the control room's microphone signal (source
defined in Settings - Mixer) is sent to the Phones. The microphone level is adjusted with the
channel's input fader.
External Input. Switches Main monitoring from the mix bus to the ste-
reo input defined in Settings (F3). The relative volume of the stereo
signal is adjusted there as well.
Assign. Allows to define the Main Out, Main Out
B, and up to four Phones outs.
The output for the Cue signal, which is usually
Main, can also be set to one of four Phones out-
puts. The setting Cue/PFL to also controls the
PFL monitoring.
User's Guide HDSPe AIO Pro © RME
46