eisenblatter PIPE SNIPER 802 HT Original Instructions Manual page 16

10. Accessories
Use genuine Eisenblätter accessories.
Use only accessories which fulfi l the requirements
and specifi cations listed in these operating instructions.
Accessories PIPE SNIPER® 802 HT
Item
38663
Ball joint mount
38702
Accessory set coarse grinding to perfect mirror fi nish
50104
Solid heavy-duty transport case
11. Repairs
Repairs to electrical tools must be carried out
by qualifi ed electricians ONLY!
If the connection lead is damaged, it must be
replaced by a new connection lead.
Contact your Eisenblätter representative if you
have Eisenblätter power tools requiring repairs.
You can download a list of spare parts from
www.eisenblaetter.de
12. Warranty
The product is protected by a 1-year warranty as of the
date of purchase. Should this product be found to be de-
fective in any way, you will have a right of redress against
the vendor. None of your statutory rights and/or legal
remedies shall be in any way restricted by the following
warranty.
12.1 Warranty Conditions
The warranty period shall commence upon the date of
sale. Please keep the original invoice in a safe place, as
this document is required as proof of purchase.
Should this product develop any material or fabrication
defects within one year as of the purchase date, we shall
either repair it for you free of charge or replace it at our
discretion. This warranty service is predicated on our
receiving both the faulty device and the original receipt
within the 1-year warranty period along with a written
description of the fault and its date of occurrence.
If the defect in question is covered by our warranty then
you shall be furnished either with a repaired or replace-
ment device (where appropriate successor). The warranty
period shall not restart upon your taking receipt of said
repaired or replacement device.
12.2 Warranty Period and Statutory Warranty Claims
The warranty period shall not be extended as a
result of our fulfi lling the warranty conditions /
providing the warranty service. The same applies
to components we may replace or repair. Any
damages or defects present at the time of sale
must be reported immediately after unpacking
the product. Any repairs required after the end
of the warranty period will incur a charge at the
going rate.
16
Description
12.3 Warranty Scope
This device was manufactured in accordance with strict
quality guidelines and conscientiously checked prior to
delivery. The warranty service applies to material or fabri-
cation defects only:
- Parts which are a use-related or other subject to natural
wear, as well as defects in the tool based on a
use-related or otherwise due to natural wear and tear
- Defects resulting from failure to observe operating
instructions, improper use, abnormal environmental
conditions, improper operating conditions, overloading
or lack of maintenance or care
- Defects caused by use of accessories or spare parts
that are not original Eisenblätter parts
- Tools on which changes or additions have been made
- Slight deviations from the target condition which are
insignifi cant for the value and serviceability of the tool
13. Environmental Protection
The generated grinding dust may contain harmful
substances. Dispose appropriately. Observe national
regulations on environmentally compatible disposal and
on the recycling of disused machines, packaging and
accessories.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Directive 2002/
96/EC relating to electrical and electronic waste
and implementation of national law, used electrical tools
must be collected separately and disposed of in an
environmentally friendly manner at recycling centres.
EN