eisenblatter PIPE SNIPER 802 HT Original Instructions Manual page 14

- Do not direct the escaping particles and the exhaust air
stream at yourself or nearby persons or on dust deposits.
- Use an extraction unit and/or air purifiers
- Ensure good ventilation of the workplace and keep clean
using a vacuum cleaner Sweeping or blowing stirs up dust
- Vacuum or wash protective clothing Do not blow, beat or
brush.
5. Initial Operation
5.1 Connection to Power Mains
Before commissioning, check that the rated
mains voltage and mains frequency, as stated
on the type plate match your power supply.
Always install an RCD with a maximum trip
current of 30 mA upstream.
The red electronics signal indicator lights up briefly when
the mains plug is inserted in the socket, indicating
readiness for operation.
5.2 Setting speed
The speed can be preset via the thumb-wheel and is
infinitely variable.
Engine speed (rpm) 820 - 3.000
Power Stage 1
Power Stage 2
Power Stage 3
Power Stage 4
Power Stage 5
Power Stage 6
The VTC electronics make material-compatible
work possible and an almost constant speed, even
under load. The best way to determine the ideal speed
setting is by performing a test.
6. Switching on and off
Always guide the machine with both hands.
Switch on first, then guide the accessory
towards the workpiece.
The machine must not be allowed to draw in
additional dust and shavings. When switching
the machine on and off, keep it away from dust
deposits. After switching off the machine, only
place it down when the motor has come to a
standstill.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine with
both hands using the handles provided, stand
securely and concentrate.
14
Belt speed
820 2,5 m/sec.
1.250 3,8 m/sec.
1.700 5,2 m/sec.
2.150 6,6 m/sec.
2.600 8,0 m/sec.
3.000 9,2 m/sec.
Torque activation (with dead man's lever)
9
I
Switching on: Slide the trigger switch (9)
forwards and then push the trigger switch
(9) upwards.
Switching off: Release the trigger switch (9).
Continuous operation
Switching on: Switch the machine on as described
above. Now slide the trigger switch (9) forwards again and
release in the front position to lock the trigger switch (9)
(continuous operation).
Switching off: Push the trigger switch (9) upwards and
release.
7. Attaching the tools, working notes
Press in the spindle locking knob only when the
spindle is stationary!
The spindle lock button is required on the machine PIPE
SNIPER® only for maintenance or replacement of the
drive roller. For a normal band change, a spindle is not
necessary.
7.1 Application and handling
a) Adjusting to the required pipe diame-
ter. Infinitely variable adjustable position
from 10 to 30 mm for machined pipe
diameter.
Tip: For quick change of diameter always
remove the sanding belt from the machine!
b) Mounting of Abrasive belt
Important: Change belt with the engine
off.
• Pull back the T-lever
• Tighten the T-lever
• Fit the belt on the guide roller and
center it over the grinding belt at the front rollers
• Unleash the T-lever, tensioning the belt
Tip: Run the new sanding belt first without touching
the pipe, then adjust to desired enclosure!
c) Belt check
• switch on machine and verify the belt drive
Tip: Set speed to „1"!
• If the belt runs not exactly parallel on roller, switch off
the machine. Continue with step d)
0
EN