Start A Measure From The Physilog 5 - Gait up PhysiRun Lab User Manual

—To start a measure press the bottom right button (Connected to Ready). When the watch
displays "Ready" the sensors start recording.
NOTE: You can check that the measure is started. Each sensor is blinking green
during recording.
—To start the chronometer, you can press the bottom right button of the watch again.
—To stop the measure, press the same button. The green blinking on the sensors stops
and your files are saved on each Physilog
3.2 Start a measure from the Physilog
The measure can be started directly from the Physilog
Material required:
• 2 Physilog
®
5
To start the measure hold the button for 3 seconds on each sensor. Check that there is a
green blinking on your two sensors after releasing the button.
WARNING: If you want a synchronization between your two sensors make sure
they are blinking green in the same time. Otherwise you need to check the
configuration "Radio mode" and "Radio channel" of your sensors with the
Research Toolkit (Windows version /Mac version, User guide), tab
"Configuration".
To stop the measure hold the button for 3 seconds, the sensor shines orange, then blinks
rapidly 3 times and stops. Check that the sensors stopped blinking. The file is
automatically saved on the device.
User guide PhysiRun Lab - v1.1.1 Date: 06.05.2019
Copyright © 2018-2019, All Rights Reserved - Gait Up SA. CH-1015 Switzerland
EPFL Innovation Park, Bat C. CH-1015 Lausanne
✓
®
5.
®
5
®
5.
Gait Up SA
www.gaitup.com
TVA CHE-145.136.760
7