Protocol; How To Do A Measurement With Physilog; Start Measure From The Watch - Gait up PhysiRun Lab User Manual

2.5 Protocol

Before starting a measurement, it's important to respect a protocol which allows to get
precise results with PhysiRun Lab. Each measurement must have a static period (flat foot
without any movement). This period is essential for PhysiRun Lab analysis to calibrate the
sensor (manually or automatically) before the analysis.
WARNING: During automatic analysis, every step is analysed. For example, if you
did a part of walking during the measure and you include this part in the analysis
the results could be biased.

3. How to do a measurement with Physilog

WARNING: Before starting a measurement, please carefully read part 2.
To obtain an analysable file, you have to do a measurement with Physilog
this file by starting the device with the watch, the application or the sensors directly. For
each method your measurement files (.BIN) are saved in the sensor memory (8Go). A file
contains the raw data. Below you can check the name description:

3.1 Start measure from the watch

A measurement from the watch allows to start and stop the Physilog
a radius of 3 meters approximately).
Required material:
• Watch
• 2 Physilog
®
5
—Open the application "Remote watch" already installed on the watch.
—To connect your sensors to the watch, press the button on each sensor briefly (<1s).
Connection between watch and sensor is automatically done after few seconds. Check that
the watch app went from Connecting to Connected, as shown in the picture below.
NOTE: If the watch does not detect the sensor, you can do a soft reset by holding
the main button of the sensors for 10 seconds.
User guide PhysiRun Lab - v1.1.1 Date: 06.05.2019
Copyright © 2018-2019, All Rights Reserved - Gait Up SA. CH-1015 Switzerland
EPFL Innovation Park, Bat C. CH-1015 Lausanne
®
5
®
®
5 by Bluetooth (within
Gait Up SA
www.gaitup.com
TVA CHE-145.136.760
5. You can obtain
6