Advertisement
Mounting Up
The receiver and bracket shall be mounted to the back panel of the Serie S using the same fasteners that
hold the amplifier panel in place. Make sure the electrical interface is fully engaged to ensure proper
performance and the mounting screws need to be tight. See photo below.
Loosen and remove the two lowest fasteners on along the lower left edge of the amplifier panel. You will
need a 3mm hex (Allan) wrench. Then align the holes in the mounting bracket with the holes in the panel.
Replace the fasteners and tighten.
Do not remove the transmitter from the bracket
Using the supplied RCA to RCA cable, connect Hi/low Output of the receiver to the Hi/Low RCA input on the
REL and the LFE Output on the receiver to the LFE RCA input on the REL.
5
Advertisement
