Advertisement
Pairing
The AirShip™ wireless transmitter and receiver should be paired with each other from the factory. When the
power is applied to both units, you should find that the LED on each unit is on. If this is not the case, then it
will be necessary to pair them together. Follow the instructions below to pair the transmitter to the receiver.
1 Make sure that the transmitter AC to DC wall plug supply is connected to an AC outlet, and that the barrel
connector is connected to the transmitter.
2 Make sure that the receiver AC to DC wall plug supply is connected to an AC outlet, and that the barrel
connector is connected to the receiver.
3 Turn the transmitter power switch on and a blue LED on the input face of the transmitter will indicate the
unit is on by blinking in the standby pattern which is one flash per second.
4 Turn the receiver power switch on.
5 At this point the transmitter and receiver should find each other and pair together. This will be indicated
by the "Pair" LEDs on both the transmitter and control panel staying lit (no flashing).
6 In the event that the transmitter and receiver do not automatically pair, simply exercise the momentary
"Pair" buttons on the transmitter and the receiver.
Status
Standby
Care and Polishing
The enclosures are best maintained by using a light automotive spray-on wax and a micro fiber cloth. Take
care not to spray the aluminum badge. Do not place objects, such as drinks on top of your REL AirShip™
transmitter. Never use a dry cloth on this finish.
Technical
The AirShip™ transmitter provides true REL Theater Reference™ connectivity, permitting both HIGH-LEVEL
and LFE channels to be wirelessly fed to Serie S. This occurs with virtually zero delay and a complete
absence of compression.
Paired
LED Indicator
Continuously on
Blinks once per second
13
Advertisement
