Braun MultiQuick 1 Manual page 10

$ Mixing beaker
%
Chopper «hc»
Please clean all parts before
using for the first time – see
paragraph «Cleaning»
How to operate your
handblender (A)
The hand blender is perfectly suited
for preparing dips, sauces, soups,
mayonnaise and baby food as well
as for mixing drinks and milk shakes.
1. Insert the motor part
blender shaft
locks.
2. To avoid splashing, insert the
handblender into the vessel first,
only then press switch
You can operate the handblender in
the mixing beaker
in any other vessel. When blending
directly in the saucepan while cooking,
take the pan from the stove first to
protect your handblender from over-
heating.
Recipe example: Mayonnaise
200–250 ml oil
1 egg (yolk and white)
1 tbsp. lemon juice or vinegar
Salt and pepper to taste
Put all ingredients into the beaker
according to the a.m. order.
Introduce the handblender to the
base of the beaker, switch it on and
keep it in this position until the oil
emulsifies. Then, without switching
off, slowly move it up and down until
the mayonnaise is well combined.
Vanilla-Honey-Prunes
(as a pancake stuffing or spread):
10
!
into the
#
and turn until it
‚
.
$
and just as well
Fill 40 g prunes (cut in half) and 50 g
clear honey (both chilled) into the
chopper bowl and mix for 5 seconds,
then add 10 ml water (vanilla-
flavoured) and resume mixing for
3 seconds.
How to operate your
chopper attachment (B)
(a) Upper part
(b) Blade
(c) Chopper bowl
(d) Anti-slip-base
(not to be used as lid)
The chopper is perfectly suited for
chopping meat, cheese, onions,
herbs, garlic, chilis (with water),
carrots, walnuts, hazelnuts,
almonds, prunes etc.
N.B.: Do not chop extremely hard
food, such as ice cubes, nutmeg,
coffee beans or grains.
Before chopping ...
– pre-cut meat, cheese, onions,
garlic, carrots (see processing
guide),
– remove stems from herbs, shell
nuts,
– remove bones, tendons and
gristle from meet.
Chopping
1. Caution: Carefully remove the
plastic cover from the blade (b).
The blade is very sharp! Always
hold it by the upper plastic part.
Place the blade on the centre pin
of the chopper bowl (c). Press
down the blade and turn 90° to
lock it. Always make sure that the
anti-slip base (d) is attached to
the bowl.