Danfoss NovoCon S Digital Installation Manual page 2

Installation Guide
❽
Common ground shall be
used for all devices on the
same network.
❾
BACnet presettings
⓫
NovoCon® S
Hybrid
NovoCon® S
Digital
Safety Note
To avoid injury and damage to persons and
devices, it is absolutely necessary these
instructions are carefully read and observed
prior to assembly and commissioning.
Necessary assembly, start-up, and maintenance work must
be performed only by qualified, trained and authorised
personnel.
Switch off the power line before wiring the actuator.
VI.HU.G3.02 / 003Z8047
®
NovoCon S Digital/Hybrid High Accuracy Actuators
NovoCon® digital cable
Digital port
Analog port or
voltage booster
NovoCon® analog cable
Digital port
BV:0
Analog (default)

or
Digital Control

Red Power
Black Common ground for power and bus signal wire
Green ´+´ non-inverting signal wire
White/ ´−´ inverting signal wire
green
Red Power
Black Power ground
Grey Analog input
Blue Analog input ground
❿
DIP Switch
1 2 3 4 5
DIP Switches 1 to 7 are used to assign the MAC address
manually. Default setting is Auto MAC addressing. For
termination of last unit on the BACnet bus, turn DIP
Switch 8 ON.
Dip switches 9 and 10 are not used.

MSV:3
Select Valve Type
(default AB-QM
DN 15)
Safety Note
Connect via safety isolating transformer.
Galvanic separations shall be provided for
segments crossing buildings.
Disposal instruction
Always follow the local disposal regulations.
6 7 8 9 10
ON
OFF
AV:0

Design Flow Rate
Produced by Danfoss A/S © 05/2015