Table of Contents
Advertisement
Cleaning and Maintenance
Cleaning
If the machine is stored in a cold room, it
should be brought to a warm room about
one hour before use.
Cleaning
Clean the machine after every use
· turn power switch to 0
· remove presser foot and needle
· open the free-arm cover
· press the stitch plate down at back
right corner
· lift and remove it
· clean the area with the brush
· replace the stitch plate
30
Cleaning the screen and the machine
· wipe with a damp cloth
Sewing light
Replacing the bulb
· turn power switch to 0
· loosen the screw
Warning:
Light bulbs get hot.
Allow to cool down before
romoval!
Cleaning the hook
· turn power switch to 0
· remove the bobbin case
· push the release lever to the left
· push the locking lever to the left and
fold down the hook race cover
· remove the hook
· clean the hook race with a cloth or
brush, never use a sharp instrument
· replace the hook, turning the
handwheel if necessary so that the
hook driver is on the left
· close the hook race cover and secure
with the locking lever, the locking pin
must engage
· check by turning the handwheel
· insert the bobbin case
· remove the cover
· remove the bulb
· insert the new bulb
· replace cover and
tighten screw
Note:
Use bulb type
12 V 5 W.
W 2.1 x 9.5 d.
Note:
For models with new sewing light see page 31.
Refer to the safety instructions!
Important:
Never use alcohol, petrol,
white spirit or any type of
solvent to clean the
machine!
Lubricating
This machine is equipped
with a LM (low mass) hook
system which requires no
lubrication. If however you
do lubricate any parts,
always run the machine
immediately afterwards on
scrap material to avoid
soiling your work.
Hide quick links:
Advertisement
Table of Contents
