Fixing To The Adjacent Units; Kitchen Plinth Adjustment - Zanussi ZD 684 Instruction Booklet

Fixing to the adjacent units

To prevent the dishwasher tilting, it must be secured
to either the worktop or adjacent kitchen
cabinet/wall using the brackets supplied.
Insert the two fixing brackets into the slots provided
in the top front part of the dishwasher as shown in
the figure.
Secure the brackets to the adjacent units with the
3.5 x 16 screws using the upper or the side holes.
The appliance must be secured to the underside
of the worktop using the brackets provided.
Failure to do this could cause damage or injury.
Attention!
The sides of the dishwasher must never
be drilled to prevent damage to hydraulic
components.

Kitchen plinth adjustment

To allow correct opening of the door it is sometimes
necessary to cut the kitchen plinth. Refer to the
cutting table.
According to dimensions (a) and (b) as shown on
the figure, you will find on the following table the
depth (x) of the cut to be made on the plinth.
The dimensions (a) and (b) of the table are those
most frequently used in the kitchen furnitures.
Height (a)*
170 160 150 140 130 120 110 100
40
136 131 125 118 110 100 93 85
50
135 131 125 118 110 102 92 85
60
137 132 125 118 110 102 94 85
70
138 134 128 120 110 104 95 85
80 / 139 130 124 115 105 98 88
90 / /
138 129 120 110 100 90
100 / / /
135 125 115 105 95
600 mm
( )
dimensions in mm
*
minimum
Dimensions of the cut on the plinth
II54
II59
a
90
II15
75
75
75
X
75
78
80
85
X
25
b
INS48en