Craftsman 13AC26JD293 Fast Start Manual

Slide the pedestal cap onto the steering shaft.
1
Remove the shoulder bolt and lock nut from the
steering shaft. Align the steering wheel so that
with the tractor wheels straight, the large opening on
the steering wheel is facing forward. Lower the steering
wheel assembly onto the lower steering shaft and secure
with shoulder bolt and lock nut. Remove the pedestal
cap mount screw factory installed and located on the
tractor's steering console. Slide the Pedestal cap down
onto the tractor and slightly rotate to the right to clip
into place. Secure the pedestal with the screw.
Remove the shoulder bolts and lock nuts
2
from the seat mounting bracket. Remove
the two self-tapping screws factory
installed on the tractor. Align the seat bracket in
place over the holes from where the self-tapping
screws were removed secure the seat bracket with
the self-tapping screws previously removed.
© 2018
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING.
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
Brake
Pedal
Shift
Ignition
Lever
Switch
Throttle
Control
Oil Fill /
Dipstick
Position the seat assembly over the seat mounting
bracket, aligning the holes provided. Install the two
shoulder bolts and lock nuts removed from the
seat mounting bracket.
Fast Start Guide
Make sure that the deck chute/mulch
plug are properly installed and the safety
switch on the deck surface is depressed.
Note: The engine will not start if the safety switch
Fuel Cap
is not depressed.
PTO (Blade
Engage) Lever
Need Help?
www.CRAFTSMAN.com or Call 1-888-331-4569
3
4
2
A
A
B
B
A
B
778-15398