Advertisement
Available languages
Available languages
Other information
<For U.S.A>
Federal Communications Commission Radio
Frequency Interference Statement
Note:
• This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
– Consult the Panasonic Service Center or an experienced radio/TV technician for help.
Warning:
• Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
Responsible party
Panasonic Corporation of North America
Two Riverfront Plaza, Newark, NJ 07102, USA
Support contact: http://business.panasonic.com/support-computerstablets
<For Europe>
Disposal of Old Equipment
Only for European Union and countries with recycling
systems
This symbol on the products, packaging, and/or accompanying
documents means that used electrical and electronic products must not
be mixed with general household waste.
For proper treatment, recovery and recycling of old products, please take them
to applicable collection points in accordance with your national legislation.
By disposing of them correctly, you will help to save valuable resources
and prevent any potential negative effects on human health and the
environment. For more information about collection and recycling, please
contact your local municipality.
Penalties may be applicable for incorrect disposal of this waste, in
accordance with national legislation.
Declaration of Conformity (DoC)
"Hereby, Panasonic declares that this Active Pen is in compliance
with the essential requirements and other relevant provisions of EU
Council Directives."
Authorised Representative:
Panasonic Testing Centre
Panasonic Marketing Europe GmbH
Winsbergring 15, 22525 Hamburg, Germany
<India Only>
Declaration of Conformity with the requirements of the E-Waste (Management) Rules
The Product is in conformity with the requirements of the reduction of hazardous
substances of the E-Waste Rules.
The content of hazardous substance with the exemption of the applications listed in
SCHEDULE II of the E-waste Rules:
1. Lead (Pb) – not over 0.1 % by weight;
2. Cadmium (Cd) – not over 0.01 % by weight;
3. Mercury (Hg) – not over 0.1 % by weight;
4. Hexavalent chromium (Cr6+) – not over 0.1 % by weight;
5. Polybrominated biphenyls (PBBs) – not over 0.1 % by weight;
6. Polybrominated diphenyl ethers (PBDEs) – not over 0.1 % by weight.
For the purpose of recycling to facilitate effective utilization of resources,
please return this product to a nearby authorized collection center,
registered dismantler or recycler, or Panasonic service center when
disposing of this product.
Please see the Panasonic website for further information on collection
centers, etc. , or call the toll-free number below.
Website:
http://www.panasonic.com/in/corporate/sustainability/panasonic-india-i-recycle-program.html
Service helpline: 1800 103 1333 or 1800 108 1333
Description of parts
❶
❷
❸
1 Pen tip
Use the product by touching this part to the screen.
2 Button 1
The function varies depending on the type of app and settings. (Press the end closest
to the pen tip.)
3 Button 2
The function varies depending on the type of app and settings. (Press the end closest
to the cap.)
4 Battery holder
Insert the battery here.
5 Cap (screw type)
• Enable the Active pen in the touch operation mode settings of the unit (see the
Reference Manual for more information).
• Use the product perpendicularly to the screen.
• The product may not operate correctly if it is tilted too much or if the pen tip is not
pressed enough.
Inserting a battery
1
Rotate the cap to open it, turn over the product, and take out the
battery holder.
2
Check the positive and negative terminals of the battery, and insert
the battery into the battery holder.
3
Return the battery holder with the + end first, and attach the cap.
• Check that there is no debris or dirt
inside the product or around the
battery holder before returning the
battery holder.
• Check that the cap is not tilted, and
firmly attach it so that it is not loose.
Replacing the pen tip
The pen tip must be replaced when it becomes worn down or damaged, and
unresponsive. Refer below for the replacement procedure.
• Make sure to use the included replacement tips.
• If the tip becomes too short, it will be difficult to pull out. Replace the tip before it
becomes too short.
• Using a damaged pen tip may scratch the screen.
1
Clasp the tip with a tool such as pliers, and
pull it out in the direction of the arrow.
2
Insert the replacement tip straight into the
product as illustrated.
• Insert the tip all the way in.
• Do not apply excessive force during insertion.
Troubleshooting
If you experience any trouble while using this product, refer to the following information
for basic troubleshooting. If the trouble persists, contact your technical support
representative.
The product
• The battery is not inserted correctly. Remove the battery and
sometimes does
insert it correctly.
not operate or
• The battery is depleted. Replace it with a new one.
respond.
• Check the following settings of the unit.
– Is the stylus pen turned on in the touch operation mode
settings?
– Is Active pen selected as the stylus pen type in the
advanced settings of the touch operation mode?
Specifications
Battery
One AAAA alkaline battery
Dimensions
Diameter: 11 mm (0.5 in.) (excluding protrusions)
Length: 131 mm (5.2 in.)
Weight
Approx. 20 g (0.05 lb) (including battery)
Operating temperature
5 °C to 45 °C (41 °F to 113 °F)
Operating humidity
30 % to 80 % relative humidity (no condensation)
❹
❺
Advertisement
