Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zeagle ReZort 310-5210
Summary of Contents for Zeagle ReZort 310-5210
- Page 2 This owner’s manual uses signal words recommended by the American National Standards Institute (see ANSI Z535.4) to des- ignate levels of hazard seriousness. These signal words and their designations are as follows: DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. This signal word is to be limited to the most extreme situ- ations.
-
Page 3: Table Of Contents
Pages Table of Contents: Introduction – Safety Information Warranty Information Disclaimer and Limitation of Remedy Nitrox Use ReZort First Stage Features 7, 8, 9 Second Stage Features Pre-Dive Lever Octopus Use Wet Breathing Pre-Dive Check Post-Dive Care Maintenance Specifications Service Record... - Page 4 Scuba equipment and Buoyancy Control Devices. Zeagle Systems and our worldwide network of authorized dealers are always ready to serve you. For more information on our products, and for the dealer nearest you, visit our web site at www.zeagle.com. Thank you for choosing Zeagle! Safety Information Read these instructions carefully before using your regulator, and keep this manual for future reference.
- Page 5 Under this limited warranty, Zeagle will either repair or replace, at its sole option, any original equipment or parts that fail to perform as intended. Shipping and Labor charges are not included and must be paid by you.
-
Page 6: Disclaimer And Limitation Of Remedy
Zeagle expressly limits any and all warranties, expressed or implied, to the terms of the limited warranty as set forth above. Your remedies are... - Page 7 This owner’s manual is in no way meant to be a substitute for the instruction received from a certified scuba training agency. 2. Zeagle regulators must be serviced only by dealers or technicians trained and authorized to service Zeagle Scuba equipment. At no...
- Page 8 CAUTION 1. The high-pressure outlets (HP Ports) are dis- tinctly larger than the low-pressure outlets. Only devices with fittings, hoses and components designed for the full tank pressure that the regu- lator will be mounted on, such as Submersible Pressure Gauges, are to be installed in these ports.
-
Page 9: Nitrox Use
NITROX USE Zeagle regulators are manufactured using materials suit- able for use with oxygen enriched gases (i.e., Nitrox, etc.) providing the oxygen content does not exceed 40%. The regulator must be kept “Oxygen Clean”... -
Page 10: Rezort First Stage Features
The ReZort first stage reduces the high pres- sure air contained in the cylinder to an intermediate pressure of approximately 135 psi (9.2 BAR). Zeagle first stages are designed to do this with outstanding reliability. The ReZort first stage comes in Yoke (310-... -
Page 11: Second Stage Features
ENVOY SECOND STAGE FEATURES The Zeagle Envoy second stage is pneumatically bal- anced and is among the most advanced diver adjustable breathing systems available. No fixed or “automatic” system can achieve an ideal level of breathing perfor- mance under all conditions. -
Page 12: Octopus Use
NOTE: Ask your authorized Zeagle Scuba dealer for in-store instructions and training on the use of the Dive / Pre-dive Venturi Lever. Your dealer will show you how to make adjustments to get the desired breath- ing results. To actually experience the effects of the... -
Page 13: Wet Breathing
WET BREATHING The Envoy second stage is much “drier” than many other second stage designs during use. However, it must be remembered that water (including the diver’s own saliva) will always settle to the bottom of the case. If the diver is in an unusual position (i.e. head down or upside down looking upwards) the exhaust valve is no longer at the bottom of the case and the mouth tube is at the bottom. -
Page 14: Post-Dive Care
4. Turn the tank valve on slowly, check for air leaks and proper breath- ing function of the regulator. If any unusual leaks are heard, do not dive with the regulator. Take the regulator to your authorized Zeagle dealer for inspection and repair if necessary. -
Page 15: Maintenance
MAINTENANCE It is essential that your regulator is checked at least annually by an authorized Zeagle regulator technician. Unusually heavy use, or use in dirty or contaminated water may result in the need for more frequent service. A service record has been provided at the end of this manual to... -
Page 16: Specifications
SPECIFICATIONS A. FIRST STAGE REGULATOR MODEL: ReZort p/n 310-5210 (Yoke), or 310-5220 (DIN) FEATURES: Lightweight Flow-by Piston regulator with high-flow capabilities. 1.4 lb. (.64 kg.) WEIGHT 120-150 psi (8-10 bar) INTERMEDIATE PRESSURE # LOW PRESSURE PORTS # HIGH PRESSURE PORTS MATERIALS: Brass Body... -
Page 17: Service Record
Service Record Date: Service: Date Purchased:... - Page 18 Notes: The date of purchase, dive store and contact information for the store, should be written on this page. A copy of the receipt could also be stapled to this page for future records.
- Page 19 Zeagle Systems Inc. 37150 Chancey Road, Zephyrhills, FL, 33541 Phone: (813) 782-5568 Fax: (813) 782-5569 www.zeagle.com Revision - C p/n 175-1646 © 2007 Zeagle Systems, Inc. 08/07...