Sharp SD-SG11 Operation Manual page 30

SD-SG11
Recording to a MiniDisc from a CD (continued)
Notes:


Recording from a CD to a MiniDisc starts even if all the tracks on the CD cannot fit
in the MiniDisc. In that case, both the CD and MD stop when the MD becomes full.


When the CD reaches its end, recording to MD will stop simultaneously.


You can record from a CD you programmed.


Recording can be performed in repeat playback mode. The repeat playback can
be switched during recording.
To stop recording:
Press the CD or MD button.
The CD and MiniDisc will stop.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
About track numbers:
New track numbers will be created automatically according to the original tracks
(Synchro mark function).


When you record from a CD to a MiniDisc, the track numbers recorded on the
MiniDisc may not match the track numbers on the CD.
CD
First track
Track A
MiniDisc
First track
Track A
E-27
Second track Third track
Track B Track C
Second track Third track
Track B Track C
Notes for long recording mode (LP2/LP4):


Tracks recorded in 2 times long recording or 4 times long recording mode cannot
be played with units that do not support these modes.


On such a unit, "LP :" is displayed at the beginning of the track and no sound is
heard. (The operation and the display may vary depending on the unit.)
Note for high speed recording:
If the source CD is of poor quality due to scratches or dirt, recording at high speed
may be unreliable. It may be recorded with noise or pauses. If this occurs, set record-
ing speed to normal.
Caution for 4 times long recording (LP4):
To realise 4 times long stereo recording, special compression methods are used.
Due to the high levels of compression the sound quality may be adversely affected
and some noise may be recorded. If sound quality is the main concern it is recom-
mended that 2 times long or normal recording is used.
01/7/9 25-37.fm