Sharp SD-SG11 Operation Manual page 46

SD-SG11
Enhancing Your Stereo System (continued)

Listening to the playback sounds from the
connected equipment
1
Press the AUX button to select "AUX ANALOG" or "AUX DIGITAL".
In analog input
In "AUX DIGITAL" input, "NO SIGNAL" may be displayed depending on the connected
equipment.
2
Play the connected equipment.
3
Adjust the volume using the VOLUME buttons.

Recording on a MiniDisc (Normal record-
ing)
1
Press the AUX button to select "AUX ANALOG" or "AUX DIGITAL".
2
Load a recordable MiniDisc into the MD compartment, label side fac-
ing toward you.
3
Press the REC button.
4
Play the connected equipment.
5
Press the REC LEVEL/CURSOR or button to adjust the recording
level.
0dB
Level meter


Maximum level should not exceed "0dB".


The recording level can be adjusted at 2dB intervals between - 4dB and + 10dB.


If the recording level is too low, the sound volume will be decreased. If it is too high,
the sound will be distorted.
6
Press the MD button.
E-43

Recording on a MiniDisc (Sound synchro-
nized recording)
1
Press the AUX button.
In digital input
2
Load a recordable MiniDisc into the MD compartment, label side
facing toward you.
3
Press the S-SYNC
4
Play the connected equipment.


Recording will start automatically.


The recording level is the level adjusted in the previous recording. (This level can
also be adjusted while recording.)

Headphones


Before plugging in or unplugging the headphones, reduce the volume.


Be sure your headphones have a 1/8"(3.5 mm) diameter plug and are between 16
ohms and 50 ohms impedance. The recommended impedance is 32 ohms.


Plugging in the headphones disconnects the speakers automatically. Adjust the
volume using the VOLUME buttons.
-4dB ··· +10dB
Recording level
REC button on the remote control.
01/7/12 38-48.fm