Sharp CD-DD4500 Operation Manual page 35

Timer and Sleep Operation (continued)
6
Press the TUNING/TIME (W W W W W or X X X X X ) button to specify the minutes,
then press the MEMORY/SET button.
7
The unit will enter the timer stand-by mode automatically.
To cancel the timer playback/timer recording:
Press the POWER button to turn the power on.
8
When the preset time is reached, playback or recording will start.
The volume will increase gradually until it reaches the volume you were listen-
ing at before your system enters the timer stand-by mode.
9
In timer playback:
If you select CD or TAPE, the unit will enter the stand-by mode after the playback.
If you select TUNER or DVD/VCR, it will enter the stand-by mode one hour
after the timer playback starts.
In timer recording:
When recording tape reaches its end, the timer recording will end, and the
unit will enter the stand-by mode.
The timer playback/timer recording setting will be cancelled if any other op-
eration than volume control is performed during its operation.
To reset or change the timer setting:
Perform "Timer playback or Timer recording" from the beginning.
Notes:
Once the time is set, the setting will be retained until a new time is entered.
When performing timer playback or recording using another unit connected to the
VIDEO/AUX IN or DIGITAL IN sockets, select "DVD/VCR" in step 2. At this time,
only this unit will be turned on or enter the power stand-by mode automatically.
(Another unit will not be turned on or turned off.)
Sleep operation
1
Play back the desired sound source.
2
Press the TIMER/SLEEP button repeatedly until "SLEEP" is dis-
played.
To change the sleep time:
Whilst the sleep time is displayed, press the TUNING/TIME (X or W) button.
(Maximum: 3 hours - Minimum: 1 minute)
3 hours - 5 minutes 5-minute intervals
5 minutes - 1 minute 1-minute intervals
3
Press the MEMORY/SET button.
4
Your system will enter the power stand-by mode automatically
after the preset time has elapsed.
The volume will be turned down 1 minute before the sleep operation finishes.
To cancel the sleep operation:
Press the POWER button whilst sleep operation is performed.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button whilst sleep operation is performed.
The remaining sleep time is displayed for about 5 seconds.
Note
:
Once the sleep time is set, it will remain unchanged until a new time is entered.
Listening to the Radio (See page 19.)
CD-DD4500
ENGLISH E-34
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15