Advertisement
TUBE REPLACEMENT
The Roc Pro 1000 circuitry consists of one Fender
special design 12AX7A tube (part #099-5091) . For
continued optimum performance from your amplifier,
this tube should only be replaced with a tube of the
same type and specification.
TOLEX COVERING CARE
Your Roc Pro 1000 is covered in genuine Tolex for
long life and lasting good looks. To clean the Tolex
covering, use a sponge and a light soapy water
solution. Avoid spilling liquids on the operating
surfaces, grill, volume and tone controls, switches and
speakers. ALWAYS unplug your amplifier before
cleaning or approaching it with fluids.
TROUBLESHOOTER'S CHECKLIST
If the amp is set up but does not function, check the following items:
•
Is the power cord properly plugged into an electrical outlet?
•
Is there power at the outlet?
•
Is the speaker properly connected to the amplifier?
•
Are all the control knobs turned above zero?
•
Is the volume control on the instrument turned up?
•
Is the instrument properly plugged into the amplifier?
(Eliminate any effects pedal and try using another cord.)
If after checking all of the above and your amplifier is still not performing
correctly, consult your authorized Fender Service Center.
Advertisement
