Getting Started - Hisense Babysense V65-1 User Manual

Note:
1. If you RESET the monitor with a pin, the monitor will be forced to shut down
2. Do not open the ba�ery compartment without following the official instruc�ons.

GETTING STARTED

Step 1:
1.
Connect the camera to the supplied AC Adapter
2.
Plug the AC Adapter into the wall electrical outlet
(Once the camera is plugged in, a red power LED light on the
Camera will turn ON for 10 seconds, indica�ng the camera is on)
Note: It is advised to place the camera at least 3 �/1m away from the crib/bed/playpen
Step 2:
Connect the monitor to the supplied AC Adapter
1.
Plug the AC Adapter into the wall electrical outlet.
2.
Hold the power bu�on down for a few seconds to turn
3.
the monitor on; once on, you will see the Babysense Logo.
Note: The monitor takes up to 4 hours to fully charge and
the ba�ery life once fully charged is approximately 4 to 5 hours,
due to the HD func�onality.
We HIGHLY recommend that the monitor be kept
plugged in at night to prevent low ba�ery warnings.
15. Antenna
16. Ba�ery Compartment
17. Support Stand
18. Speaker
19. Power Input
20. Reset Hole