Relay Playback; To Stop Relay Playback - Kenwood X-W320 Instruction Manual

This function plays back the tapes in both decks A and B
continuously and repeatedly.

Relay playback

1
Load cassette tapes in both decks.
2 Insert cassette tapes and close the cas-
2
Determine the playback condition.
2 Select the Dolby NR mode.
3
Start playback.

To Stop relay playback

Press the 7 key of the deck that is playing.
Downloaded from: http://www.usersmanualguide.com/
1 Open the cassette holders of decks A and
B.
0
sette holders of decks A and B.
A
1 Select the playback mode.
REV.
MODE
DOLBY NR
2
7
2 7
÷ Be sure to remove tape slack before insertion.
B
÷ Be sure to close the cassette holder securely by pushing it.
Each press sw itches the indication.
1 " [ " : Relay playback of tw o sides of tapes in decks A and B is
2 " " " : Relay playback is not available w ith this setting.
3 " " " : Relay playback of only one side of tapes in decks A and
Each press sw itches the indication.
1 DOLBY NR " OFF" (extinguished): Dolby NR is not used.
2 DOLBY NR " B" : Noise reduction of the ordinary type.
3 DOLBY NR " C" : Noise reduction w ith higher performance.
÷ Select the Dolby NR mode according to the tape recording status.
3
÷ The playback starts w ith the deck the play key of w hich is pressed.
3
Listening to cassette tapes
repeated.
B is repeated.
X-W 3 2 0 (En)
1 3