Recording Of Cd Playback (Ccrs) (Deck B Only) - Kenwood X-W320 Instruction Manual

The "CCRS function" can be used to start recording by setting the optimum recording level for the recorded CD automatically.
Please note that the edit recording (CCRS) is not possible w ith an LD player.
Preparation
1 (Set the input selector key of the
2 (Load a disc in the CD player.)
3 (Edit tracks as required on the CD player.)

Recording of CD playback (CCRS) (Deck B only)

1
Insert a tape in deck B.
2
Determine the recording condition.
2 Select the Dolby NR mode.
3
Press the CCRS key.
How to cancel CCRS
During recording level setting:
Press the Stop key of the CD player or the stop key
of the cassette deck.
During CCRS recording:
Press the Stop key of the CD player, then press the
OPEN / CLOSE key of the CD player.
After completion of CCRS recording:
Press the OPEN / CLOSE key of the CD player.
1. If the CCRS key is pressed during CD playback, playback stops and CCRS operation begins.
2. If the remaining amount of tape is small, CCRS may not function correctly or CCRS operation may be canceled in mid-operation.
3. Once the CCRS recording level has been set, the recording balance and recording level cannot be adjusted w hile the CCRS operation is
being carried out.
4. The CCRS function sets the peak level for the entire CD in approx. 20~200 seconds. On very rare occasions, how ever, the function may
Notes Notes
not be able to set the optimum recording level. If this occurs, carry out recording manually referring to the "Ordinary recording" section.
5. With CD players equipped w ith the EDIT function, it is possible to make recordings in w hich the last songs on sides A and B are not cut
off in the middle and in w hich the recording capacity of the tape is used to the fullest extent. (Set the REV.M ODE key of the deck to " [ " .)
Downloaded from: http://www.usersmanualguide.com/
AV CONTROL CENTER to CD.)
1 Select the recording mode.
REV.
MODE
DOLBY NR
CCRS
: Keys and control used in the operations described on this page.
÷ For the tape direction setting, see the description below " Select the
tape transport direction" .
Each press sw itches the indication.
1 " [ " :Double-side recording.
2 " " " :(Tape also stops after having recorded both sides.)
3 " " " :One-w ay recording.
Each press sw itches the indication.
1 DOLBY NR " OFF" (extinguished): Dolby NR is not used.
2 DOLBY NR " B" : Noise reduction of the ordinary type.
3 DOLBY NR " C" : Noise reduction w ith higher performance.
÷ Select the Dolby NR mode according to the tape recording status.
÷ Program-edit recording is not possible w hen tracks of more than one
CD are programmed using a Carrousel type CD player.
÷ The CCRS indicator blinks, and actual recording starts in about 20 to 200
seconds (after creating a non-recorded blank of about 8 seconds).
÷ After recording, the cassette deck and CD player enter the stop mode
automatically.
Synchro playback/recording
X-W 3 2 0 (En)
!
^
2 3