Specifications - Kenwood X-W320 Instruction Manual

Specifications

Track System ................. 4 track, 2 channel stereo
Recording System .......... AC bias (Frequency: 105 kHz)
Heads ............................... A DECK
M otors.............................. A DECK ............. DC motor × 1
Wow and Flutter ............. ±0.19 % (IEC)
Fast Winding Time ......... Approx. 100 seconds (C-60 tape)
Frequency Response
TYPE tape ..................... 40 Hz to 18,000 Hz, ±3 dB
TYPE tape .................... 40 Hz to 19,000 Hz, ±3 dB
Signal to Noise Ratio
Dolby NR OFF ................ 56 dB
(IEC, 250 nWb/ m, TYPE tape)
Dolby NR OFF ................ 59 dB
Dolby B NR ON .............. 68 dB
Dolby C NR ON .............. 75 dB
(3rd, H.D., 3 %, TYPE tape)
Harmonic Distortion ....... Less than 1.9 %
(at 315 Hz, 3rd H.D., 250 nWb/ m, TYPE tape)
Input sensitivity/ Impedance
LINE IN ........................... 123 mV/ 47 kΩ
Output Level/ Impedance
LINE OUT ....................... 775 mV/ 1.0 kΩ
[General]
Pow er Consumption ...... 20 W
Dimensions...................... W: 400 mm (15-3/ 4")
Weight (Net) .................... 4.8 kg (10.6 lb)
1. KENWOOD follow s a policy of continuous advancements in development. For this reason specifications may be changed w ithout notice.
2. The full performance may not be exhibited in an extremely cold location (under a w ater-freezing temperature).
Notes Notes
For CANADA
Canadian IC Compliance Notice
NOTICE: This Class B digital apparatus meets all requirements of the Canadian interference-Caussig Equipment Regulations.
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
NOTE:
This equipment has been tested and found to comply w ith the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful
interference to radio communications, if it is not installed and used in accordance w ith the instructions. How ever, there is no guarantee that
interference w ill not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, w hich can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the follow ing
measures:
– – Reorient or relocate the receiving antenna.
– – Increase the separation betw een the equipment and receiver.
– – Connect the equipment into an outlet on a circuit different from that to w hich the receiver is connected.
– – Consult the dealer or an experienced radio/TV technician for help.
Downloaded from: http://www.usersmanualguide.com/
Playback head ................... 1
B DECK
Playback/ recording heads 1
Erasing head ..................... 1
B DECK ............. DC motor × 1
±0.28 % (DIN)
0.1 % (W.R.M .S)
H: 141 mm (5-9/ 16")
D: 390 mm (15-3/ 8")
X-W 3 2 0 (En)
3 5