Relay Playback - Kenwood CT Series Instruction Manual

This function plays back the tapes in both decks A and B
continuously and repeatedly.
12

Relay playback

1
Load cassette tapes in both decks.
Deck A:
Playback only. (CT-203/
KXF-W 4010 only)
Playback/recording avail-
able. (CT-2050/KXF-W 6010
only)
2
Determine the playback condition.
3
Start playback.
To Stop relay playback
Downloaded from: http://www.usersmanualguide.com/
1
Open the cassette holders of decks A and
B.
0
2
Insert cassette tapes and close the cas-
sette holders of decks A and B.
Deck B: Play-
b ac k / r e c o r d i n g
available.
A
1
Select the playback (recording) mode.
REV.MODE
2
Select the Dolby NR mode.
DOLBY NR
2 7
Press stop (7) key of the deck that is
playing.
2 7
: Keys and control used in the operations described on this page.
÷ Be sure to remove tape slack before insertion.
÷ Be sure to close the cassette holder securely by pushing it.
B
Each press sw itches the indication.
1 "[" : Relay playback of tw o sides of tapes in decks A and
2 """ : Relay playback is not available w ith this setting.
3 """ : Relay playback of only one side of tapes in decks A
Each press sw itches the indication.
1 DOLBY NR "OFF" (extinguished): Dolby NR is not used.
2 DOLBY NR "B": Noise reduction of the ordinary type.
3 DOLBY NR "C": Noise reduction w ith higher performance.
÷ Select the Dolby NR mode according to the tape recording status.
3
÷ Tapes are played in the directions indicated by their respective indicators
on the display.
÷ The playback starts w ith the deck the play key of w hich is pressed.
3
Listening to cassette tape
CT-2 0 5 0 / 2 0 3 / KXF-W 6 0 1 0 / W 4 0 1 0 (En/ M )
B is repeated.
and B is repeated.