Table of Contents
Advertisement
Troubleshoot ing Guide
The follow ing messages are displayed w hen certain problems are occurring in your system. Take the
recommended actions.
No disc magazine has been loaded in the changer. The disc magazine is not completely loaded.
EJECT
] Load the disc magazine properly.
No CD in the unit.
] Insert the CD.
No disc has been loaded in the disc magazine.
NO DISC
] Load a disc into the disc magazine.
No disc has been loaded in the disc magazine.
E-04
] Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-dow n. The CD is scratched a lot.
] Clean the CD and load it correctly.
Nothing has been recorded on the M D.
BLANK
No tracks are recorded on the M D, although it has a title.
NO TRACK
The faceplate of the slave unit being connected to this unit has been removed.
NO PANEL
] Replace it.
The unit is malfunctioning for some reason.
E-77
] Press the reset button on the unit. If the "E- 77" code does not disappear, consult your nearest service center.
Something is w rong w ith the disc magazine. or the unit is malfunctioning for some reason.
E-99
] Check the disc magazine. And then press the reset button on the unit. If the "E- 99" code does not disappear, consult your
nearest service center.
The protective circuit in the unit activates w hen the temperature inside the automatic disc changer exceeds 60°C (140°F),
HOLD
stopping all operation.
] Cool dow n the unit by opening the w indow s or turning on the air conditioner. As the temperature falls below 60°C (140°F),
the disc w ill start playing again.
The M D player section is not operating properly.
IN
] Reinsert the M D. If the M D cannot be ejected or the display continues to flash even w hen the M D has been properly
reinserted, please sw itch off the pow er and consult your nearest service center.
— 30 —
Advertisement
Table of Contents
