Setting The Address Of The Digipeater Route - Yaesu FTM-300DR Instruction Manual

Setting the address of the digipeater route

After selecting PATH 1 - PATH 4 / FULL 1 / FULL 2 under [APRS] → [16 DIGI PATH
SELECT] in the set-up menu, enter the specific address information (callsign and ALIAS).
A maximum of 2 addresses for PATH 1 - PATH 4, and a maximum of 8 addresses for FULL
1 - FULL 2 can be registered.
Example: Enter the address information of PATH 1
1
Press and hold the [F(SETUP)] key → [APRS] → [15 DIGI PATH 1].
Switch to the address selection screen.
2
Rotate the DIAL knob to select the [ADDRESS 1], then press the DIAL knob.
The address input screen will be displayed.
3
Enter the address.
Refer to "Text input screen" (FTM-300DR/DE Operating Manual) on how to enter text.
4
Press and hold the DIAL knob.
The entered callsign will be displayed in the setting field under [ADDRESS 1].
5
Rotate the DIAL knob to select the [ADDRESS 2], then press the DIAL knob.
6
Enter the address.
7
Press and hold the DIAL knob.
The entered callsign will be displayed in the setting field under [ADDRESS 2].
8
Press the [DISP] key or press the PTT switch to return to the operating screen.
27