Toshiba Tecra S1 Series Resource Manual page 27

Installing additional memory (optional)
Your computer comes with enough memory to run most of
today's popular applications. You may want to increase the
computer's memory if you use complex software or process
large amounts of data.
Additional memory comes in 128 MB, 256 MB, and 512 MB
modules. There are two memory slots. Your system may have
both slots occupied.
You need a standard Phillips no. 1 screwdriver to install a
memory module.
If the computer is on, begin at step 1, otherwise, skip to step
3.
1 Shut down your computer completely using the Shut
down or Turn Off command.
2 Unplug the computer and remove any cables you may
have connected.
3 Turn the computer upside down.
4 Locate and remove the screw that holds the cover plate in
place, and lift the cover off the memory module bay.
Setting up your computer and getting started
Before you install or remove a memory module, turn off the computer
using the Start menu. If you install or remove a memory module
while the computer is in Stand By or Hibernation mode, data will be
lost.
If you use the computer for a long time, the memory modules will
become hot. If this happens, let the modules cool to room
temperature before you replace them.
To avoid damaging the computer's screws, use a standard Phillips
no. 1 screwdriver that is in good condition.
Do not install or remove a memory module while the DVD-ROM
drive power is on.
Installing a memory module with the computer's power on may
damage the computer, the module, or both.
27