Husqvarna T Series Operator's Manual page 6

Function
The machine is used for sucking and separating dry, non-combustible dust with an explosion limit value of
3
.
>0.1mg/m
The engine is started by the key switch. When the engine has warmed up and is running at idle, the clutch is
engaged by a second switch. Dust laden air is then sucked through the inlet valve at high speed via the suction
hose. The air is slowed down by the cyclone and coarse dust particles are separated out, partly by centrifugal
force and partly by gravity. Air and finer particles then pass through the tube filter where separation takes place.
The machine is designed for filter cleaning by reverse air pulse.
The separated dust accumulates in the cyclone until the machine is switched off, when it drops through the
bottom flap into the plastic bag.
Before starting the machine, check that the inlet valve is open and that the clutch is disengaged
Use
Before use, the user must be trained in the handling of the dust extractor and the hazardous dust.
Before starting the engine, check the service table for daily maintenance
The filter must be cleaned from time to time. This must be done before changing the plastic bag. It can also be
done when the work is complete or when there is poor suction.
Procedure: While running the machine, seal the inlet using the inlet valve. Let the machine build up vacuum for
a few seconds (approx. 5 sec.) then quickly push down on the top handle and release it slowly. Repeat this
procedure 5 times. If suction remains poor, the filter should be replaced. The plastic bag may only be replaced
after cleaning the filter.
The plastic bag must be tied up after removal. Only use original parts.
Warning
Warning
5