All Cameras Tab - Art ARTTRACK1 System User Manual

8.5.1.1 All Cameras tab

By default the window opens up showing the tab
camera specific settings (e.g. flash intensity, camera orientation, syncgroup assignment)
either for all cameras at once (globally) or for each camera separately by left-clicking and
selecting the appropriate entry. When cameras are removed from an already calibrated
tracking system (e.g., due to a disconnected cable) without performing a room recalibra-
tion the ART Controller will detect and mark them as missing. The corresponding entries
are greyed out to show that the cameras have been disabled. The only data shown is
model and serial number.
The following settings can be accessed (from left to right):
Column
Camera
Model
Serial
Flash intensity
Static reflex suppr.
Sync group
Camera mode
Room cal
Flash settings The flash intensity may be changed within an interval from
0 .. 6 for ARTTRACK1
0 .. 8 for ARTTRACK2
ARTTRACK5
0 .. 100 for
0 .. 7 for TRACKPACK
These settings strongly depend on the working area and range. If you are working in a
small area, where you are close to the cameras, lower flash intensities may be sufficient.
Otherwise, if your typical working distance is further away from the cameras (but still
within tracking range of the cameras), higher flash intensities may be necessary. Adjust
the flash intensity that tracking quality of all cameras is suitable using the
display . Please refer to chapter 8.3.3.1 on page 135 for instructions.
Description
Shows the assigned camera ID (see 2-digit LED matrix dis-
play on ARTTRACK5 )
Shows the type of camera
Shows ART internal serial number of each camera
Change the currently selected flash intensity (set individually)
(De-)activates the static reflex suppression for this camera
(set individually)
Select the syncgroup
TRACK5 ARTTRACK5/C
,
ally)
Select the camera mode (available modes depend on model,
set individually)
Shows the status of room calibration (i.e. 'no' for newly added
but not yet calibrated cameras)
,
/ ARTTRACK3 ,
ARTTRACK5/C
, and
.
8.5 Menu Settings
All Cameras. Here you can change
('Channel 1' - 'Channel
TRACKPACK/E
& , set individu-
TRACKPACK/E
ART-
3' for
Monitor 2DOF
147