Adding Wireless Inertial Sensors - Art ARTTRACK1 System User Manual

7.1.2.1 Adding wireless inertial sensors

In the menu Settings
inertial sensors in range (see figure 7.1 on page 107).
In the upcoming dialogue (see figure 7.3 on page 109) you should find the
being 'USB'. Please change the mode to
box. In this mode DTrack2
if the current channel of dongles / sensors has been set differently. In case the dongles
/ sensor channels have been set manually, please change the scan mode to 'single' and
select the corresponding channels in the adjacent selection box.
Press Scan and the system will identify all sensors in range running on the specified chan-
nels. Expect 15 inertial sensors for a complete
checkboxes of all sensors to be added to the configuration in the column
all sensors by ticking
If you cannot remember the current radio channel of your sensors,
you can either choose 'all' to scan all channels (from 1 to 80, note:
this takes some time) or identify the sensors via wired connection. To
this end connect all sensors to the
cable and select the scan mode 'USB'. All attached sensors will be
listed together with their corresponding channel.
Take care that all inertial sensors are assigned to a radio channel of
one of the dongles; otherwise such a sensor cannot be used during
measurement. Also take care that (roughly) the same number of sen-
sors are assigned to each dongle.
After adding the sensors the dialogue
shows all available dongles and their assigned sensors with the following
sensor properties:
Inertial Sensor , press
Figure 7.3: Adding wireless inertial sensors
'default
will search for the sensors on default channels 35 and 55, even
'accept all'. Then press
Inertial Sensor Settings
7.1 Hybrid motion capture suit
Add sensor to identify and connect all
channels' using the adjacent selection
ART
Hybrid Motion Capture suit. Tick the
Apply and exit this dialogue.
ART Controller via a USB charging
(see figure 7.4 on 110) now
Scan mode
Accept or add
109